INSTALLED HEATING - STORAGE HEATERS

XL6/XLS6 Range

Technical Specification

Construction Details

Galvanised finish sheet steel base mounted on pressed steel feet, supporting double skin front

and outer panels.

Internal Details

1 Storage Core

Material: High density bonded magnetite bricks.

2 Heating Element

Type: Incoloy sheathed 850W.

3 Thermal Insulation

Type (a) Front and Rear Panels – microporous silica.

Type (b) Top and Ends – resin free mineral wool.

Type (c) Base – calcium silicate slab.

4 Supply Connection

Located at front right hand end of base. Cable entry bush and cable clips allow neat supply cable entry from either side of heater.

5 Assembly

Remove one piece grille/front panel assembly then front inner skin. Remove internal packing and element, position rear layer of bricks, heating element, and front layer of bricks.

Controls

1 Charge Controller – XL

Type: Bi-metal factory pre-set for fully charged condition.

2 Thermal Safety Device

Type: Bi-metal – manual reset.

IP Rating

Drip-proof IPX2.

Packing

1 Case Assembly

Containing assembled heater case and heating element. Packed in single carton.

2 Storage Bricks

Supplied, 2 bricks per pack. Approx brick weight 7.5kg each.

3 Finish

Willow White top, sides and front panel.


Model XL6, XLS6
Performance Input Rating 0.85kW
Charge Acceptance 7 hr 5.95kWh
Height 700mm
Width 332mm
Depth 170mm
Height above floor 88mm
Weight without bricks 11kg
Weight with bricks 41kg


† When using Dimplex shelves a clearance of 150mm must be maintained.
A clearance of 75mm must be maintained between the heater surface and any curtains.

Name and Registered Office: Dimplex (UK) Limited, Millbrook House, Grange Drive, Hedge End, Southampton, Hants, SO30 2DF, United Kingdom.
Company No.1313016 EEE Producer Registration Number – WEE/GE0057TS