You are here
VFMi 40kWh Fan Storage Heater
VFMi 40kWh Fan Storage Heater
The VFMi range of fan storage heaters blends all the benefits of using low-tariff electricity with a highly insulated heater to give maximum controllability over heat delivered.
Material: High density bonded magnesite bricks.
Type: Incoloy sheathed, 3 elements per heater.
Front and Rear Panels – microporous silica.
Top – microporous silica.
Base and sides – vermiculite.
Located at right hand side to rear of heater – accessible by removal of side panel assembly. 240V 1 phase or 415V 3 phase. Note: Heat resistant cable required for connection to heater.
A secure wall fixing is required for all heaters with suitable connection to the fixed wiring of the premises.
Galvanised sheet steel base, mounted on pressed steel feet. Side panels, front panel/air outlet grille assembly and inner skin removable for brick loading.
Charge Controller Type: Hydraulic, manually adjustable from zero charge to fully charged condition.
Thermal Safety Device
Type: Bi-metal – automatic reset.
Type: Integral room temperature sensing hydraulic thermostat fitted at installation stage. Accurate to ±1°C. Temperature range approximately 5°C to 30°C. On/Off switch for fan. On/Off switch with neon for direct acting heating element (option).
240V single phase (415V 3 phase option may be selected on installation).
VFM24i – approx. weight 44kg.
VFM32i – approx. weight 51kg.
VFM40i – approx. weight 57kg.
VFM48i – approx. weight 63kg.
Packed separately in packs of 3 (see table for weight of product with bricks). Pack Part No. 007781 approx. weight 16.7kg.
Front panel, top panel, side panels – RAL9016 – Traffic White.
Grille – Birch Grey.
|Colour/Finish/Material||Traffic white with a birch grey grille|
|Controls||1. Charge Controller: Hydraulic, manually adjustable from zero charge to fully charged condition. 2. Thermal Safety Device: Bi-metal - automatic reset. 3. Output Control: Integral room temperature sensing hydraulic thermostat fitted at installation st|
|Installation||A secure wall fixing is required for all heaters with suitable connection to the fixed wiring of the premises.|
|Insulation||A secure wall fixing is required for all heaters with suitable connection to the fixed wiring of the premises.|
|Location of Heat Output||Grille at bottom front and sides|
|Storage Capacity (kWh)||40|
|Product model number||VFM40i|
|Cable Exit Point||Right|
|Cable Length (m)||Supplied by Installer|
|Charge Acceptance 7 hours (kWh)||40|
|Construction||Galvanised sheet steel base, mounted on pressed steel feet. Side panels, front panel/air outlet grille assembly and inner skin removable for brick loading.|
|Element type||Incoloy sheathed, 3 elements per heater.|
|Fan Rating (on peak supply) (W)||25|
|Number of bricks||30|
|Safety Cut Out||Bi-metal - automatic reset|
|Suitable for which room/s||Bedroom, Bathroom, Lounge, Dining Room, Hallway and Landing, Utility Room, Study|